Installation Recommendations
Installing the profiles on the facade is recommended before applying the decorative plaster.
• Installing the profiles on the facade is recommended before applying the decorative plaster.
Profiles should be installed at an outdoor temperature between 5°C and 25°C on dry surfaces, free of grease or other substances.
• Profiles should be installed at an outdoor temperature between 5°C and 25°C on dry surfaces, free of grease or other substances.
The surfaces on which the decorative profiles will be installed should not have irregularities exceeding 1 cm per meter.
• The surfaces on which the decorative profiles will be installed should not have irregularities exceeding 1 cm per meter.
• Measure to determine the height and width of the window/door opening, the width of the casing, and the height and width of the sill. Attention! The thickness of the casing must be less than the thickness of the sill.
• Measure to determine the height and width of the window/door opening, the width of the casing, and the height and width of the sill.
ATTENTION! The thickness of the casing must be smaller than the thickness of the sill.
Mark a 45-degree angle using a square.
• Mark a 45-degree angle using a square.
Use a fine-tooth saw to cut along the marking.
• Use a fine-tooth saw to cut along the marking.
The profiles are adhered to the facade using bagged polystyrene adhesive or polyurethane adhesive (polyurethane foam) for polystyrene.
• The profiles are adhered to the facade using bagged polystyrene adhesive or polyurethane adhesive (polyurethane foam) for polystyrene.
The same adhesive/foam is used for joining them.
• The same adhesive/foam is used for joining them.
For supporting large profiles during adhesion to the facade, mechanical fasteners (dowels, nails) are used.
• For supporting large profiles during adhesion to the facade, mechanical fasteners (dowels, nails) are used.
Our mineral resin is used to finish the joints.
• Our mineral resin is used to finish the joints.
Before painting, the profiles must be completely dry and cured. After applying the primer, wait 24 hours before applying the exterior paint or plaster.
• Before painting, the profiles must be completely dry and cured. After applying the primer, wait 24 hours before applying the exterior paint or plaster.
